(202) 760-4589 [email protected]

What Causes a Door to Warp & When to Call a Door Repair Company!

Your solid wood door may warp or bow throughout its life. Warping can occur in almost every type of door, including interior and exterior, solid, hollow, and raised panels. This applies to both new and old doors, but it is especially true for older doors. But why does it warp in the first place, and when should you contact door replacement services? What else should you know before enlisting the help of door installation services?

What exactly is warping?

Wood warping is a malformation that can occur in a variety of woods. It happens when the other components of the wood do not change in the same way. For instance, if one part of the wood dries faster than the other, the wood may shrink. Manufacturers and sellers try to avoid warping, but it usually occurs after the finished product is delivered to the customer. It is advised that a door be replaced if it has gotten significantly warped. If the door is not badly bent, a door repair service can fix it. 

Why do doors warp?

To put it simply, wood warps are caused by uneven drying of the wood fibers within them. Wood with a higher moisture content is more prone to warping than wood with lower moisture content. Wood can also warp as a result of the amount of moisture in the air. Warping can also be caused by a rise in humidity, heat, or moisture entering your doors. The amount of shrinkage and warping varies from piece to piece of wood.

Warping on doors becomes more noticeable as damp wood dries up in the spring and summer months. Taller doors are more likely to warp than shorter ones. Aside from the causes described above, your door could warp for other reasons.

Excessive Heat

It is possible that too much heat will cause the door to expand. This is caused by a moisture imbalance between your home’s exterior and interior. As a result of the quick rise in temperature, the wood may fracture or split.

Excessive Moisture

Wood swells when it is damp or humid. Because the problem is so widespread, some builders require homeowners to keep their air conditioners turned on to honor their warranties.

Stripped Screws

Check the screws that keep the door together. You may notice that the door starts to catch as you open or close it if they are stripped. Reduce the pressure when drilling the new screws as the door starts to lift into the stud.

Only One Side of the Door is Finished

To extend the life of the wood, doors are frequently glazed over with a clear finish after they have been painted. Some homeowners, on the other hand, choose different treatments for their doors to achieve a specific aesthetic, such as a stained or vintage look. The door may warp if only one side is painted or if each side has a different finish.

Improper Sealing

Removing a door from the doorjamb and sealing it will not do much if it is already warped. When you get a new door, make sure to seal all six sides while they are all even. Not many homeowners know, but the manufacturer or seller may void any existing warranties if you do not seal all six sides. If you are storing away new doors until they are ready to be installed, keep them somewhere dry.

Door repair services from MacArthur Locks & Doors

Now that you know why your door may be warped, where can you find door repair Washington DC? When hiring door installation Washington DC, MacArthur Locks & Doors is always there, seven days a week. They guarantee customer satisfaction, so you can rest assured that you get nothing but the best service.

Call Now ButtonCall Now